






Clean damaged area with Cotol-240™ Cure Accelerator/Precleaner or solvent (paint thinner, nail polish remover or similar).
Trim loose threads. Non-fabric surfaces should be roughened with sandpaper, then cleaned. Apply Aquaseal® to surfaces directly from tube or with knife or flat stick. Keep repair level overnight. Avoid contact with other surfaces.
Most repairs reach full strength overnight (10-14 hours). Allow longer for thickest repairs. For fastest cure (2 hours or less), mix in Cotol-240.
HOLES AND TEARS: Create backing with removable tape. Fill void and 1/4" beyond edge with Aquaseal. Remove tape after full cure.
SEAMS: Apply 1/16" thick bead overlapping seams edges by at least 1/4". Apply with slight pressure to saturate fabric surfaces.
HIGH WEAR AREAS: Apply thin coat with knife for flexible abrasion resistance.
WARNING: FULLY CURED AQUASEAL IS SLIPPERY WHEN WET. For added traction on footwear, sprinkle sand on uncured Aquaseal 1/2 hour after applying.
CLEAN UP: To remove Aquaseal from hands, buff with cloth soaked in paint thinner, nail polish remover or 99% isopropyl alcohol.
STORAGE: Advance contents to tube neck. Wipe clean and cap. Keep in cool, dry place; for extended life, place in freezer. To thaw or for easier-flowing contents, soak tube in warm water for 15 minutes.
Product Info
Cotol-240™ Cleaner & Cure Accelerator is a urethane cure accelerator and pre-cleaner to be used in conjunction with Aquaseal® or . The solvent cleans and prepares the surface, readying it for Aquaseal® , speeding the tack time to 15 minutes and the full cure time to less than two hours. Cotol-240 is also ideal for removing tar, sap, glue, and other resins from various surfaces including glass, plastic and metal. Available in 1/2 oz. Blister Pack, 4 oz. and Quart (not shown).
Instructions for Use
Cotol-240™ Directions for use with Aquaseal® Urethane Repair Adhesive, Seam Grip® Outdoor Repair Adhesive & Seam Sealer and Freesole® Urethane Repair Adhesive:
AS PRECLEANER:
1. Apply a small amount to the damaged area (spot test for colorfastness).
2. Rub with a clean cloth until dry.
3. Repeat steps 1 and 2.
4. Apply Aquaseal as directed. Note: for best adhesion, first roughen non-fabric surfaces with sandpaper.
AS CURE ACCELERATOR:
1. Thoroughly mix 1 part cure accelerator with 3-4 parts Aquaseal® or using a stick, toothpick, or knife. Mix on a non-absorbent surface such as a plastic lid or plate.
2. Immediately apply the mixture to the damaged area.
3. Allow the repair to completely cure at least 2 hours before using.
FOR COLORS: Mix food coloring or paint colorant (available at paint stores) into the Aquasure and cure accelerator before applying.
CLEAN-UP: To remove Aquaseal® from hands, use cloth soaked with paint thinner, nail polish remover or 99% isopropyl alcohol.
STORAGE: Cap tightly. Store in cool, dry place. Use blister card package for storage.
Top of Page