Cotol-240™ Cleaner & Cure Accelerator is a urethane cure accelerator and pre-cleaner to be used in conjunction with Aquaseal® or . The solvent cleans and prepares the surface, readying it for Aquaseal® , speeding the tack time to 15 minutes and the full cure time to less than two hours. Cotol-240 is also ideal for removing tar, sap, glue, and other resins from various surfaces including glass, plastic and metal.

Cotol-240™ Directions for use with Aquaseal® Urethane Repair Adhesive, Seam Grip® Outdoor Repair Adhesive & Seam Sealer and Freesole® Urethane Repair Adhesive:

AS PRECLEANER:

1. Apply a small amount to the damaged area (spot test for colorfastness).

2. Rub with a clean cloth until dry.

3. Repeat steps 1 and 2.

4. Apply Aquaseal as directed. Note: for best adhesion, first roughen non-fabric surfaces with sandpaper.

AS CURE ACCELERATOR:

1. Thoroughly mix 1 part cure accelerator with 3-4 parts Aquaseal® or using a stick, toothpick, or knife. Mix on a non-absorbent surface such as a plastic lid or plate.

2. Immediately apply the mixture to the damaged area.

3. Allow the repair to completely cure at least 2 hours before using.

FOR COLORS: Mix food coloring or paint colorant (available at paint stores) into the Aquasure and cure accelerator before applying.

CLEAN-UP: To remove Aquaseal® from hands, use cloth soaked with paint thinner, nail polish remover or 99% isopropyl alcohol.

STORAGE: Cap tightly. Store in cool, dry place. Use blister card package for storage.